K1 Max camera stops #508
Replies: 10 comments 17 replies
-
Also getting this problem on a K1 with the self-added camera. |
Beta Was this translation helpful? Give feedback.
-
I have same issue with K1C. |
Beta Was this translation helpful? Give feedback.
-
My camera has stopped working as well since the last update. The CPU maxing out at 100%. |
Beta Was this translation helpful? Give feedback.
-
Are you guys by chance heating your enclosed chamber? I have had zero problems with the K1C camera on the latest script and firmware...until I closed it up, turned on my chamber heater (my own added that tops out at 50°C), and attempted to print ABS. Twice now, the camera has cut out once the temps get high in the chamber. My chamber temps top out around 70°C during the print - 60°C reported by the cheap-ass temp sensor, but 70°C confirmed by me with an IR gun. The camera, of course, gets to this temp, too. I'm wondering if the [certainly cheap, based on vid quality,] camera sensor they used has an upper temp limit of a wee bit lower than that and it is simply cutting out and crashing the driver. I do not have any cam issues when printing PLA with the top off, as the camera never gets above 40°C. Unfortunately, I seem to remember the same thing happening on 1.3.3.5, but I had only done one ASA print at that point and just rebooted when it was done and moved on with my usual PLA/PETG prints with the cover off and chamber unheated. So, are y'all closing up the chamber during print and/or heating it when your cam dies? Have you checked the temp of the cam housing after it dies? |
Beta Was this translation helpful? Give feedback.
-
Software or heat the time the camera stops working is between 1--1.5 hrs consistently. Chamber was 34C at the point of failure. IT also appears the mjpg streamer is custom(??). tail /var/log/messages |
Beta Was this translation helpful? Give feedback.
-
My issue actually has resolved itself🤷 I have only been printing ASA with the machine closed up. |
Beta Was this translation helpful? Give feedback.
-
My camera died and creality replaced it. these are photos of dead camera from my K1 Max. |
Beta Was this translation helpful? Give feedback.
-
I wired it to USB cable, 5V drops to 4.6V, no 3V3 and it gets very hot. is not recognised as USB device on PC. |
Beta Was this translation helpful? Give feedback.
-
more info here with data sheets of parts used. |
Beta Was this translation helpful? Give feedback.
-
After some digging I found this file and command on the K1 Max:
This reloads the video services without a reboot. |
Beta Was this translation helpful? Give feedback.
-
Everything worked well until this last update. Now the camera starts when the machine is turned on. While printing the camera stops working and says unable to load Webcam. I have to reboot the printer to get it to work again.
Beta Was this translation helpful? Give feedback.
All reactions