You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
First of all a big thanks to everyone involved in developing the helper script. It helped me a lot! In order to make it a bit better I thought I'd give you some feedback on a problem I faced and possibly ask for a correction concerning screw-tilt-adjust. When running this the parking position over the back left screw is too close to the heat bed in order to get a key into the screw when adjusting the height. I therefore propose that either the height is being set by a parameter that can be changed or possibly raise the position from 5 to say 40 in order to get to the screw.
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
First of all a big thanks to everyone involved in developing the helper script. It helped me a lot! In order to make it a bit better I thought I'd give you some feedback on a problem I faced and possibly ask for a correction concerning screw-tilt-adjust. When running this the parking position over the back left screw is too close to the heat bed in order to get a key into the screw when adjusting the height. I therefore propose that either the height is being set by a parameter that can be changed or possibly raise the position from 5 to say 40 in order to get to the screw.
Beta Was this translation helpful? Give feedback.
All reactions