Replies: 2 comments 4 replies
-
"KAMP uses information from [exclude_object] to define mesh bounds. Complicated slicer parameter passing is finally a thing of the past. Welcome to the future!" Perhaps this is an issue with exclude_object parameters? |
Beta Was this translation helpful? Give feedback.
-
I have the solution! In Fluid, open the configuration menu and browse to the /Helper-Script/KAMP folder and edit the KAMP_Settings.cfg file. Look for the following line: |
Beta Was this translation helpful? Give feedback.
-
K1 Max w.1.3.3.26 firmware, factory install, w/script+enough stuff to run KAMP:
Some of my complex objects need tall support, which Orca w/auto Trees with default settings go all the way to the bed, but when those supports go "south" of the object, they can intersect with the KAMP purge line, leading to poor integrity for that support or set of supports.
I can rotate the object and not have an issue, but I figured I should document this in case others have seen it.
Beta Was this translation helpful? Give feedback.
All reactions