examples/LEDs: add README.md file

examples/LEDs/README.md

@@ -0,0 +1,106 @@
+# LEDs and basic GPIO example application
+
+## Description
+
+This basic example allows easy, interactive control of internal board LEDs,
+and basic GPIO for externally connected simple devices (for e.g. additional
+LEDs, relay, motors - via dedicated drivers, etc.).
+
+In particular, this example shows:
+- on/off and toggle internal board LEDs.
+- initialize GPIO port in output mode.
+- set GPIO port state to HIGH or LOW.
+
+## Shell command
+
+The following commands are available:
+
+- `led0`, `led1` ... `led7`: allows switching on/off or toggle internal board
+ LEDs. Number of commands depends on internal LEDs number.
+- `init`: call before interact with GPIO port to initialize chosen port in
+ output mode, which allows setting it to HIGH or LOW state.
+- `set`: sets GPIO port state to HIGH.
+- `clear`: sets GPIO port stet to LOW.
+- `help`: default RIOT command, which shows available commands.
+
+## Example on `native`
+
+- Build and run `LEDs` example application on the `native` target,
+as Linux application:
+
+```
+$ make term
+[...]
+RIOT native interrupts/signals initialized.
+RIOT native board initialized.
+RIOT native hardware initialization complete.
+
+main(): This is RIOT! (Version: 2021.07-devel-10893-gb2e97-example-LEDs)
+LEDs, version 1.0.0
+>
+```
+
+Or run it directly without terminal. Go to `RIOT/examples/LEDs` and run
+commands:
+
+```
+$ make
+[...]
+$ ./bin/native/LEDs.elf
+RIOT native interrupts/signals initialized.
+RIOT native board initialized.
+RIOT native hardware initialization complete.
+
+main(): This is RIOT! (Version: 2021.07-devel-10893-gb2e97-example-LEDs)
+LEDs, version 1.0.0
+>
+```
+
+- List the available commands:
+```
+> help
+help
+Command Description
+---------------------------------------
+init GPIO pin initialization
+set Set GPIO pin to HIGH
+clear Set GPIO pin to LOW
+led0 Switch on/off on-board LED0
+led1 Switch on/off on-board LED1
+```
+
+- Enable internal LED0 and LED1 (the `native` target has two virtual LEDs):
+
+```
+> led0 on
+led0 on
+LED_RED_ON
+
+> led1 on
+led1 on
+LED_GREEN_ON
+```
+## Example on sample board - stm32f469i-disco
+
+- Build and flash `LEDs` example application on sample board, for example
+ `stm32f469i-disco` target, which has 4 internal LEDs:
+
+```
+$ make BOARD=stm32f469i-disco flash term
+[...]
+main(): This is RIOT! (Version: 2021.07-devel-10894-g2ad22b9-example-LEDs)
+LEDs, version 1.0.0
+> help
+help
+Command Description
+---------------------------------------
+init GPIO pin initialization
+set Set GPIO pin to HIGH
+clear Set GPIO pin to LOW
+led0 Switch on/off on-board LED0
+led1 Switch on/off on-board LED1
+led2 Switch on/off on-board LED2
+led3 Switch on/off on-board LED3
+```
+
+- Switch on/off internal LEDs using commands `led0`, `led1`, `led2` or `led3`.