-
Notifications
You must be signed in to change notification settings - Fork 50
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Slow cooling down after peaking #248
Comments
Currently there is not a way to control where
So a value of 0 would be the current behavior and then as Alternatively, different interpolators could be implemented. The current interpolator is a monotonic Hermite cubic spline. The key is the monotonicity, which guarantees the bounds of |
We used Livneh dataset (daily Tmax, Tmin, and precipitation) to generate hourly tempeature data at a location in California (40.03N, 122.16W). We chose tdf=0.8 (Tmax timing) as the default parameter value (0.67) yields earlier tempearature peaks. However, the recession is slower (slow cooling down after the peak) compared to the observed hourly tempeature (referring to the figure attached). Are there any other parameters that can be tuned to resovle the slow colling down issue?
The text was updated successfully, but these errors were encountered: