You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I'm new to ESP32. I managed to flash ESP32 C3 for first time with Arduino by holding IO9 to low and IO8 to high. I got successful message to reset and I did the same.
When I'm following the same sequence to flash again the ESP32 C3 board is no more communication with Arduino. Get following error message
esptool.py v4.6
Serial port COM3
Connecting......................................
I fear that Arduino erases the boot section and it is not entering boot mode again. How to check if chip is not dead or how to bring back the chip to working
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
Hello,
I'm new to ESP32. I managed to flash ESP32 C3 for first time with Arduino by holding IO9 to low and IO8 to high. I got successful message to reset and I did the same.
When I'm following the same sequence to flash again the ESP32 C3 board is no more communication with Arduino. Get following error message
esptool.py v4.6
Serial port COM3
Connecting......................................
A fatal error occurred: Failed to connect to ESP32-C3: No serial data received.
For troubleshooting steps visit: https://docs.espressif.com/projects/esptool/en/latest/troubleshooting.html
Failed uploading: uploading error: exit status 2
I fear that Arduino erases the boot section and it is not entering boot mode again. How to check if chip is not dead or how to bring back the chip to working
Beta Was this translation helpful? Give feedback.
All reactions