-
-
Notifications
You must be signed in to change notification settings - Fork 4
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Install Klipper firmware on Ender 3 S1, use with OctoPrint #10
Labels
ender-3-s1
Ender 3 S1 printer
Comments
My S1 has the STM32F401 chip. It looks like older S1s had a different chip. |
Another couple options to test out include:
Article comparing the three: Mainsail Vs. Fluidd Vs. OctoPrint - A Comparison. (Though it's a little old / dated). |
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
See install guide: Klipper Installation.
It looks like I would need to use the Ender 3 S1 config. Would be good to flip the printer and check what microcontroller is on the printer board (there are two different models out there).
Bonus: You can still use the LCD display with the Pi... though the wiring for that looks a little annoying. Would be nice to find a good way to mount up the Pi on the printer or under the display?
The text was updated successfully, but these errors were encountered: