WiFiLi

Espressif based firmware for cheap H801 RGBWW-LED-controllers.

Inspired by https://eryk.io/2015/10/esp8266-based-wifi-rgb-controller-h801/

Wiring with those red FT1232 clones:

TX - TX
RX - RX
GND - GND

Baud rate: 74880 (same as bootloader)

Use 'make term' to run miniterm.

setup

• solder some pinheaders onto serial pins and a jumper onto the other two bootloader selection pins consult https://eryk.io/2015/10/esp8266-based-wifi-rgb-controller-h801/ for details

• install Espressif SDK via https:/pfalcon/esp-open-sdk (takes ~25 minutes to build!)

• update paths in Makefile (or add SDK to $PATH), adjust /dev/ttyUSBx path

• create src/user_config.h with

    #define SSID            "your SSID here"
    #define SSID_PASSWORD   "your password here"
  

• build and flash

    make flash
  

usage

telnet $IP 1

TODO

• list of WiFi APs
• Webserver
• add physical touch buttons (for on/off, FAD, red night-light, ...)
• http://www.instructables.com/id/FADing-Fall-Asleep-Device/
• add build info to help or welcome message
• store settings to flash, so they survive power off