Pick and Place

[loca5790]

Do you have the pick and place file available? Also do you just add the custom components to the file strutuce and install via HACs?

Thanks!

[jhenkens]

The schematic is built with EasyEDA and is linked in the readme. It's built for the WT32-ETH01. If you were to edit it, I don't think the 3.5mm jack and the relay (for PA mode) are necessary - you can functionally do the exact same thing via software by turning each zone on and restoring it. I'm not sure how to export it from EasyEDA to use in other places.

The repo is mostly the esphome code running on the ESP32. The Home Assistant package is just an example package - you'd need to flush out the templates for your own zones, and then put it on disk.

[loca5790]

You should be able to export the pick and place file it is what is used to plae the elements on the BOM. SHouldn't be hard to do it without just takes a little time. If you use the program easy eda app you can export the pick and place directly in the Fabrication section.

I would love to use this just rying to figure out how to integrate it will have to do some more research. I'd be willing to buy a completed module from you if you make a place available to do so.

[loca5790]

got it figured out but I'd be interested in buying one if you woudl sell a unit.